This is Week 12. I have roughly around two weeks time before the demo presentation and I haven't place any component on PCB yet. PCB is a printed circuit board, which is used to mechanically support and electrically connect electronic components using conductive pathways, tracks or signal traces etched from copper sheets laminated onto a non-conductive substrate. However, for this time, I'm planning on using a UV board.
First, I am preparing the schematic draw of my circuit on Proteus.
 |
| Schematic diagram using Proteus |
And next, I tried to convert the diagram on PCB using Proteus. Indeed, the connection is a little bit mess up therefor i tried to draw the diagram using Diptrace. It is way lot easier.
 |
| Circuit diagram on PCB using Diptrace |
 |
| Close up of my circuit |
No comments:
Post a Comment